Intake Manifold Replacement - Right Side

Intake Manifold Replacement - Right Side

Removal Procedure




1. Remove the center intake manifold.
2. Remove the right fuel rail.
3. Remove the intake manifold bolts/nuts.

Important: The intake manifold uses sealer. Pry at the area by the fuel rail bolt holes in order to avoid damage to the sealing surfaces.

4. Remove the intake manifold.
5. To prevent entry of debris in the cylinder head tape the openings.
6. If required, clean and inspect the intake manifold. Refer to Intake Manifold Cleaning and Inspection.

Installation Procedure




1. Apply a 2-3 mm (1/8 in) wide, by 0.5-1.5 mm (1/16 in) high bead of sealant to the intake manifold. Refer to Sealers, Adhesives, and Lubricants for the correct part number.




2. Install the intake manifold.
3. Install the intake manifold bolts/nuts.

Right Side:

Notice: Refer to Fastener Notice.

4. Tighten the intake manifold bolts/nuts in the sequence shown.

Tighten the bolts/nuts to 21 N.m (15 lb ft).

5. Install the right fuel rail.
6. Install the center intake manifold.