Transfer Case Output Shaft Seal Replacement - Rear

Transfer Case Output Shaft Seal Replacement - Rear

Tools Required

J 35582 Oil Pump Seal Installer

Removal Procedure

1. Remove the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece.





Notice: Refer to Transfer Case Seal Removal Notice.

2. Using a flat-bladed screwdriver and a hammer, remove the rear output shaft seal from the transfer case.

Installation Procedure




1. Using the J 35582 and a hammer, install the rear output shaft seal into the transfer case.
2. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece.
3. Inspect the transfer case fluid level.