Braking Sensor/Switch: Service and Repair

BRAKE PEDAL POSITION SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the knee bolster trim panel.
2. Disconnect the brake pedal position sensor electrical connector.
3. Remove the brake pedal position sensor bolt.
4. Remove the brake pedal position sensor from the vehicle.

INSTALLATION PROCEDURE




1. Install the brake pedal position sensor to the vehicle.
2. Install the brake pedal position sensor bolt.

Tighten the bolt to 9 N.m (80 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the brake pedal position sensor electrical connector.
4. Install the knee bolster trim panel.