Seat Cushion Frame Replacement - Front

Seat Cushion Frame Replacement - Front

Removal Procedure

1. Remove the front seat assembly from the vehicle. Refer to Seat Replacement (Seat Replacement) .
2. Remove the front finish panel. Refer to Finish Panel Replacement - Front Seat - Front (Finish Panel Replacement - Front Seat - Front) .
3. Remove the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement (Seat Cushion Outer Trim Panel Replacement) .




4. Remove the J-Strip (1) securing the rear of the seat cushion cover to the frame.




5. Remove the push pins (2) securing the seat cover to the frame.




6. Remove the seat belt buckle bolt (2).
7. Disconnect the black electrical connector from the seat belt buckle.
8. Pull the seat belt buckle harness back through the hole in the seat adjuster assembly.
9. Remove the seat belt buckle assembly by pulling it out through the slot in the seat cushion cover.
10. Disconnect the electrical connector from the seat back harness.
11. Disconnect the lumbar electrical connector, if equipped.
12. Remove the harness clip securing the SIR harness to the seat adjuster.
13. Disconnect the seat back heating element electrical connector, if equipped.




14. Remove the seat adjuster cable (1) from the seat adjuster.
15. Remove the cable end from the seat adjuster (2) by removing the ball though the round opening.




16. Remove the 2 bolts securing the recliner assembly to each side of the seat.
17. Remove the seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Front (Seat Cushion Cover and Pad Replacement - Front) .




18. Remove the 4 nuts that secure the seat cushion frame to the power seat adjuster frame.



Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the 4 nuts that secure the seat cushion frame to the power seat adjuster frame.

Tighten the seat cushion frame mounting nuts to 24 N.m (18 lb ft).

2. Install the seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Front (Seat Cushion Cover and Pad Replacement - Front) .




3. Install the 2 bolts securing the recliner assembly to each side of the seat.

Tighten the seat recliner mounting bolts to 26 N.m (19 lb ft).

4. Install the harness clip securing the SIR harness to the seat adjuster.
5. Connect the lumbar electrical connector, if equipped.
6. Connect the electrical connector to the seat back harness.
7. Connect the seat back heating element electrical connector, if equipped.




8. Install the cable end from the seat adjuster (2) by inserting the ball though the round opening.
9. Install the seat adjuster cable (1) to the seat adjuster.
10. Install the seat belt buckle assembly through the slot in the seat cushion cover.




11. Install the seat belt buckle to the seat with the bolt (2).

Tighten the seat belt buckle bolt to 55 N.m (41 lb ft).

12. Run the seat belt buckle electrical harness through the seat adjuster.
13. Connect the electrical connector to the seat belt buckle.




14. Install the rear seat cover flaps to the frame with the push pins (2).




15. Install the J-Strip (1) on the rear of the seat cover to the frame.
16. Install the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement (Seat Cushion Outer Trim Panel Replacement) .
17. Install the front finish panel. Refer to Finish Panel Replacement - Front Seat - Front (Finish Panel Replacement - Front Seat - Front) .
18. Install the front seat assembly to the vehicle. Refer to Seat Replacement (Seat Replacement) .