Rear Door Window Regulator: Service and Repair

Window Regulator Replacement - Rear Door

Removal Procedure

1. Remove the rear door outside handle. Refer to Door Handle Replacement - Rear Outside (Service and Repair) .
2. Remove the rear door window run channel assembly. Refer to Window Run Channel Replacement - Rear Door (Window Run Channel Replacement - Rear Door) .
3. Remove the rear door lower speaker. Refer to Speaker Replacement - Rear Door in Entertainment.
4. Disconnect the electrical connector rosebuds.




5. Loosen the 2 rear module bolts.
6. Remove the 4 remaining module bolts.
7. Remove the 3 latch bolts from the door shut face.
8. Disconnect the door harness at the door jamb.
9. Remove the window regulator module from the door.



Installation Procedure





1. Install the window regulator module into the door.
2. Connect the door harness at the door jamb.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the 3 latch bolts to the door shut face.

Tighten the bolts to 10 N.m (89 lb in).

4. Install the 4 module bolts.

Tighten the bolts to 8 N.m (71 lb in).

5. Connect the electrical connector rosebuds.
6. Install the rear door lower speaker. Refer to Speaker Replacement - Rear Door in Entertainment.
7. Install the rear door window run channel assembly. Refer to Window Run Channel Replacement - Rear Door (Window Run Channel Replacement - Rear Door) .
8. Install the rear door outside handle. Refer to Door Handle Replacement - Rear Outside (Service and Repair) .