Rocker Arm Assembly: Service and Repair

Valve Rocker Arm and Push Rod Replacement

Removal Procedure

1. Remove the valve rocker arm cover(s). Refer to Service and Repair.






2. Remove the rocker arm bolt(s).
3. Remove the valve rocker arm(s) and the pushrod(s).

Installation Procedure






1. Coat the ends of the push rods using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.

Important: The intake valve push rods measure 146.0 mm (5.75 inch) in length. The exhaust valve push rods measure 152.5 mm (6.0 inch) in length.

2. Install the push rods in their original location.






3. Coat the rocker arm friction surfaces using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.

Important: Shims may be required under the valve rocker arm pedestals if reconditioning has been performed on the cylinder head or its components.

4. Install the valve rocker arms in their original positions.
5. Install the valve rocker arm bolts. Refer to Valve Rocker Arm and Push Rod Installation 79. Valve Rocker Arm and Push Rod Installation.
6. Install the valve rocker arm cover(s). Refer to Service and Repair.