Garnish Molding Replacement - Rear Upper (Avalanche/Escalade EXT)

Garnish Molding Replacement - Rear Upper (Avalanche/Escalade EXT)

Removal Procedure




1. Remove the rear window from the vehicle.
2. Remove the third pillar trim panels.
3. Remove the plastic push pins (1) from the upper garnish molding.
4. Pull down the upper garnish molding in order to disengage the retaining clips.
5. Disconnect the electrical connector, if equipped.

Installation Procedure




1. Connect the electrical connector, if equipped
2. Install the upper garnish molding until it snaps into place.
3. Install the plastic push pins (1) to the upper garnish molding.
4. Install the third pillar trim panels.
5. Install the rear window to the vehicle.