Wiper Motor Replacement - Rear

WIPER MOTOR REPLACEMENT - REAR

REMOVAL PROCEDURE




1. Remove the rear wiper arm.
2. Remove the rear wiper motor drive shaft nut.
3. Remove the washer and seal from the wiper motor drive shaft.
4. Remove the liftgate trim panel.
5. Remove the rear wiper motor screws.
6. Remove the rear wiper motor from the liftgate.




7. Disconnect the rear wiper motor electrical connector.
8. Remove the rear wiper motor from the vehicle.

INSTALLATION PROCEDURE




1. Install the rear wiper motor electrical connector.




2. Position the rear wiper motor to the liftgate.
3. Install the rear wiper motor screws.

Tighten the screws to 6 N.m (53 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the liftgate trim panel.
5. Install the washer and seal onto the rear wiper motor drive shaft.
6. Install the rear wiper motor drive shaft nut.

Tighten the nut to 6 N.m (53 lb in).

7. Install the rear wiper arm.
8. Inspect rear wiper for proper operation.