Wiper Motor Cover Replacement - Rear

WIPER MOTOR COVER REPLACEMENT - REAR

REMOVAL PROCEDURE
1. Remove the liftgate trim panel.




2. Disconnect the rear wiper motor module electrical connector.
3. Using a small flat-bladed tool, remove the rear wiper motor module cover.




4. Remove the rear wiper motor module circuit board from the rear wiper motor.

INSTALLATION PROCEDURE




1. Position the rear wiper motor module circuit board to the rear wiper motor, pressing in until fully seated.




2. Install the rear wiper motor module cover.
3. Connect the rear wiper motor module electrical connector.
4. Install the liftgate trim panel.
5. Inspect the rear wiper for proper operation.