Door Front Edge In/Out Adjustment - Sliding

Door Front Edge In/Out Adjustment - Sliding

Adjustment Procedure





1. Remove the sliding door upper garnish molding. Refer to Garnish Molding Replacement - Sliding Door (Garnish Molding Replacement - Sliding Door) in Interior Trim.

Important: Loosen only 1 bolt at a time on each bracket. Loosening more than 1 bolt may cause a loss of sliding door alignment.


2. Loosen 1 bolt on the upper roller bracket.
3. Loosen 1 bolt on the lower roller bracket.
4. Adjust the front edge of the sliding door in or out, as needed.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Tighten the bolt on the lower roller bracket.

Tighten the bolt to 25 N.m (18 lb ft).

6. Tighten the bolt on the upper roller bracket.

Tighten the bolt to 25 N.m (18 lb ft).

7. Install the upper garnish molding to the sliding door. Refer to Garnish Molding Replacement - Sliding Door (Garnish Molding Replacement - Sliding Door) in Interior Trim.