Door Adjustment - Sliding

Door Adjustment - Sliding

In and Out Adjustments


Important: When adjusting either the manual or the power sliding door, loosen only one bolt at a time on the sliding door lower roller bracket and the sliding door center roller bracket. Failure to loosen one bolt at a time may result in a complete loss of sliding door alignment.


1. Remove the sliding door garnish molding. Refer to Garnish Molding Replacement - Sliding Door (Garnish Molding Replacement - Sliding Door) in Interior Trim.
2. Remove the close-out panel on the center rear of the sliding door inner trim panel in order to access the sliding door center roller bracket bolts.




3. Loosen one sliding door lower roller bracket bolt.
4. Loosen one sliding door lower bracket bolt.
5. Adjust the front edge of the sliding door up or down as needed.

Notice: Refer to Fastener Notice in Cautions and Notices.

6. Tighten the loosened sliding door lower bracket bolt.

Tighten the bolt to 25 N.m (18 lb ft).

7. Tighten the loosened sliding door upper roller bracket bolt.

Tighten the bolt to 25 N.m (18 lb ft).

8. Loosen one sliding door center roller bracket bolt.
9. Adjust the rear edge of the sliding door in or out as needed.
10. Tighten the loosened sliding door center roller bracket bolt.

Tighten the bolt to 25 N.m (18 lb ft).

11. Install the close-out panel on the center rear of sliding door inner trim panel in order to cover the sliding door center roller bracket bolts.
12. Install the plastic plugs on the lower front sliding door inner trim panel in order to cover the sliding door lower roller bracket bolts.



Up and Down Adjustment Procedure






Important: When adjusting either the manual or the power sliding door, loosen only one bolt at a time on the sliding door lower roller bracket and the sliding door center roller bracket. Failure to loosen one bolt at a time may result in a complete loss of sliding door alignment.


1. Remove the lower front plastic plugs on the sliding door inner trim panel in order to access the sliding door lower roller bracket to door bolts.
2. Remove the close-out panel on the center rear of the sliding door inner trim panel in order to access the sliding door center roller bracket bolts.
3. Loosen one sliding door lower roller bracket bolt.
4. Adjust the front edge of the sliding door up or down as needed.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Tighten the loosened sliding door lower roller bracket to door bolt.

Tighten the bolt to 25 N.m (18 lb ft).

6. Loosen the sliding door center roller bracket bolt.
7. Adjust the rear edge of the sliding door up or down as needed.
8. Tighten the loosened sliding door center roller bracket bolt.

Tighten the bolt to 25 N.m (18 lb ft).

9. Install the close-out panel on the center rear of sliding door inner trim panel in order to cover the sliding door center roller bracket bolts.
10. Install the plastic plugs on the lower front sliding door inner trim panel in order to cover the sliding door lower roller bracket bolts.