Upper Sliding Door Roller: Service and Repair

Roller Bracket Replacement - Upper

Removal Procedure

1. Remove the sliding door garnish molding. Refer toGarnish Molding Replacement - Sliding Door (Garnish Molding Replacement - Sliding Door) .
2. Remove the headliner trim finish molding. Refer toHeadlining Trim Finish Molding Replacement (Headlining Trim Finish Molding Replacement) in Interior Trim.
3. Support the sliding door.




4. Mark the location of the sliding door upper roller bracket (1) to the door (2) with a grease pencil.
5. Remove the sliding door upper roller bracket bolts.




6. Remove the sliding door upper roller bracket from the front edge of the upper track.



Installation Procedure





1. Install the sliding door upper roller bracket to the front edge of the upper track.




2. Align the sliding door upper roller bracket (1) to the grease pencil marks.

Notice: Refer toFastener Notice in Cautions and Notices.

3. Install the sliding door upper roller bracket bolts.

Tighten the sliding door upper roller bracket bolts, in sequence as shown, to 10 Nm (89 lb in).

4. Remove the support from the sliding door.
5. Adjust the sliding door, if needed. Refer toDoor Adjustment - Sliding (Manual or Power) (Door Adjustment - Sliding (Manual or Power)) .
6. Install the headliner trim finish molding. Refer toHeadlining Trim Finish Molding Replacement (Headlining Trim Finish Molding Replacement) in Interior Trim.
7. Install the sliding door garnish molding. Refer toGarnish Molding Replacement - Sliding Door (Garnish Molding Replacement - Sliding Door) in Interior Trim.