Shift Control Knob Replacement

Shift Control Knob Replacement

Removal Procedure
1. Place the shifter in a position to gain easy access to the set screw.
2. Remove the T-15 Torx set screw.
3. Remove the shifter knob.

Installation Procedure
1. Install the shift knob on the shifter

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the T-15 Torx set screw for the shifter.
^ Tighten the T-15 Torx set screw to 5 Nm (44 inch lbs.).