Battery to Junction Block

BATTERY POSITIVE CABLE REPLACEMENT (BATTERY TO JUNCTION BLOCK)

REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.




2. Remove the rear battery cover bolts (1) and cover (2).
3. Disconnect the negative and positive battery cables.
4. Remove the positive battery cable from wire loom on top of right side frame rail.
5. Lower the vehicle.
6. Open the hood.
7. Remove the nut retaining the positive battery cable at the junction box.
8. Remove the positive battery cable from wire looms under hood.
9. Raise the vehicle.




10. Remove the positive battery cable from vehicle.

INSTALLATION PROCEDURE




1. Install the positive battery cable to vehicle.
2. Lower the vehicle.
3. Install the positive battery cable to wire looms under hood.
4. Install the positive cable and nut in the junction box.

Tighten nut to 6 N.m (53 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

5. Close the hood.
6. Raise the vehicle.
7. Install the positive battery cable to the wire looms on top of the right side frame rail.
8. Connect the negative and positive battery cables.




9. Install the rear battery cover (2) and nuts (1).

Tighten nuts to 10 N.m (89 lb in).

10. Lower the vehicle.