79. Valve Rocker Arm Cover Installation - Right

Valve Rocker Arm Cover Installation - Right





1. Important:
^ All gasket surfaces should be free of oil or other foreign material during assembly.
^ DO NOT use the valve rocker arm cover gasket again.
^ The valve rocker arm cover bolt grommets may be used again if not damaged.

Install a NEW gasket (504) into the valve rocker arm cover.





2. Install a NEW oil fill tube to the valve rocker arm cover





3. Install the valve rocker arm cover onto the cylinder head.

4. Notice: Refer to Fastener Notice in Service Precautions.

Install the cover bolts with grommets.
^ Tighten the valve rocker arm cover bolts to 12 Nm (106 inch lbs.).





5. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the ignition coil bolts (723).
6. Install the ignition coils (722), wire harness (721), and bolts (723) to the bracket (719).
^ Tighten the ignition coil bolts to 10 Nm (89 inch lbs.).





7. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the ignition coil bracket bolts (723).
8. Install the ignition coil and bracket assembly (719) and bolts (720).
^ Tighten the bracket bolts to 12 Nm (106 inch lbs.).