Rear Door Window Motor: Service and Repair

Window Regulator Motor Replacement - Rear Door

Removal Procedure

1. Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair
2. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
3. Disconnect the electrical connector from the rear door window regulator motor.




4. Remove the rear door window regulator motor to regulator screws.
5. Remove the rear door window regulator motor assembly.



Installation Procedure





1. Align the rear door window regulator motor assembly to the rear door window regulator.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the rear door window regulator motor to regulator screws.

Tighten the rear door window regulator motor to regulator screws to 8 N.m (71 lb in).

3. Connect the electrical connector to the rear door window regulator motor.
4. Install the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
5. Install the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair