Output Speed Sensor Replacement

Output Speed Sensor Replacement
Removal Procedure





1. Disconnect the wiring harness (2) from the output shaft speed sensor.





2. Remove the output speed sensor bolt (3).
3. Remove the output shaft speed sensor (2) and the O-ring (1).

Installation Procedure





1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new output speed sensor O-ring (1).
2. Install the new output speed sensor O-ring (1) onto the output speed sensor (2).
3. Install the output speed sensor (2) into the transmission case assembly.

4. Notice: Refer to Fastener Notice in Service Precautions.

Install the output speed sensor bolt (3).
^ Tighten the bolt to 6 Nm (53 inch lbs.).





5. Connect the wiring harness (2) to the output shaft speed sensor.