109. Control Valve Body Cover Installation

Control Valve Body Cover Installation





1. Clean any gasket material from the control valve body cover and inspect the gasket mounting surface.
2. Apply a 3 mm (1/8 inch) bead of sealant GM P/N 89020326 (Canadian P/N 89021188), to the cover mounting surface.





3. Install the control valve body cover (29) onto the transmission case assembly.
4. Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489), to the threads of all of the cover bolts.
5. Install the 9 - M8 x 1.25 x 15.5 mm control valve body cover bolts (28).





6. Notice: Refer to Fastener Notice in Service Precautions.

Tighten the 9 control valve body cover bolts in sequence.
^ Tighten the control valve body cover bolts to 13 Nm (10 ft. lbs.).