Hazard Warning Switch: Service and Repair

HAZARD FLASHER SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) center trim bezel.




2. Remove the screws that retain the hazard flasher switch to the I/P center stack. Remove the switch.




3. Disconnect the electrical connector from the hazard flasher switch.

INSTALLATION PROCEDURE




1. Align the switch with the trim bezel and fasten in place.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 2.5 N.m (22 lb in).




2. Connect the electrical connector to the hazard flasher switch.
3. Install the I/P center trim bezel.
4. Test the flasher switch for proper operation.