Transfer Case Input Shaft Seal Replacement

Transfer Case Input Shaft Seal Replacement

^ Tools Required
- J 42738 Seal Installer

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case assembly.

Notice: Do not damage the sealing surfaces of the transfer cases or the shafts when prying the seals for removal. Damaging the sealing surface may cause leakage or require replacement of the damaged component.

3. Remove the transfer case input shaft seal.

Installation Procedure





Important: When installing the transfer case input shaft seal, make sure that the part numbers on the seal are facing outward (toward the technician). The transfer case input shaft seal should be even with the surface of the transfer case after installation.

1. Position the transfer case input seal on the input shaft.
2. Using the J 42738, install the transfer case input shaft seal.
3. Install the transfer case assembly.
4. Inspect the transfer case fluid level.
5. Lower the vehicle. Refer to Vehicle Lifting.