Shoulder Belt Guide Adjuster Replacement - Rear

REMOVAL PROCEDURE




1. Open the cover on the rear seat shoulder belt to expose the bolt.
2. Remove the rear seat shoulder belt retaining bolt from the guide adjuster bracket.
3. Remove the left rear - C-pillar side garnish molding trim by grasping both the sides and pull rearward.
4. Remove the 2 guide adjuster bracket retaining bolts from the pillar.
5. Remove the guide adjuster bracket from the pillar.

INSTALLATION PROCEDURE




1. Install the guide adjuster bracket to the pillar.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the 2 guide adjuster bracket retaining bolts to the pillar.

Tighten
Tighten the guide adjuster bracket retaining bolts to the pillar to 20 N.m (15 lb ft).

3. Align the tabs of the C-pillar side garnish molding trim with the openings in the pillar and push inward until fully seated.
4. Install the shoulder belt retaining bolt to the guide adjuster bracket.

Tighten
Tighten the shoulder belt retaining bolt to the guide adjuster bracket to 53 N.m (39 lb ft).

5. Close the cover on the rear seat shoulder belt bolt.