Assist Step Extension Replacement - Rear

Assist Step Extension Replacement - Rear

Removal Procedure

1. Raise the vehicle to a suitable height.
2. Remove the front section of the assist step extension. Refer to Assist Step Plate Replacement (Assist Step Plate Replacement) .




3. Remove the screws from the left rear outer edge of the assist step extension.
4. Lift upward on the assist step extension until fully released from the retainer.




5. Remove the screws from the right rear inner and outer wheel well.
6. Open the sliding door to expose the screw.
7. Lift upward on the assist step extension until fully released from the retainer.




8. Remove the rear section of the assist step extension.



Installation Procedure






Important: Use the following procedure when installing the assist step extension:


* Check the height and the alignment to the rocker panel.

* Check the height and the alignment to the rocker panel cladding and to the body. If the vehicle is equipped with assist steps, the cladding will be shorter across the bottom.



1. Install the rear section of the assist step extension, align the rear edge of the assist step with the rear edge of the retainer and pushing downward until fully seated.





Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the screw to the left rear outer edge of the assist step extension. Lift upward on the assist step until fully released from the retainer.

Tighten the screw to the left rear outer edge of the assist step extension to 2 N.m (18 lb in).





3. Install the screws to the right rear inner and outer wheel well. Open the sliding door to expose the screw. Lift upward on the assist step extension until fully released from the retainer

Tighten the screws to the right rear inner and outer wheel well to 2 N.m (18 lb in).

4. Install the front section of the assist step extension. Refer to Assist Step Plate Replacement (Assist Step Plate Replacement) .
5. Lower the vehicle.