Back Window Regulator: Service and Repair

Window Regulator Replacement - Endgate

Removal Procedure

1. Swing the end gate open.




2. Remove the regulator bolt access plugs (3).
3. Remove the end gate trim panel.
4. Remove the end gate inner panel reinforcement.
5. Remove the end gate window.
6. Remove the bolt (3) retaining the regulator to the end gate.
7. Loosen the nuts (1) retaining the regulator rails to the end gate.
8. Remove the regulator by sliding the regulator side rails up and out of the keyhole slots (2) in the gate.




9. Disconnect the electrical connector from the window regulator.
10. Remove the regulator assembly from the end gate out the access hole.

Installation Procedure




1. Install the regulator assembly to the end gate through the access hole.
2. Connect the electrical connector to the window regulator.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the regulator side rails to the end gate by inserting the nuts (1) in the keyhole slots (2).

Tighten the regulator side rail nuts to 25 N.m (18 lb ft).

4. Install the bolt (3) retaining the regulator motor bracket to the end gate.

Tighten the regulator motor bracket bolt (3) to 10 N.m (89 lb in).




5. Install the end gate window.
6. Adjust the end gate window fore/aft. Refer to Window Replacement - Endgate.
7. Adjust the end gate window cross car. Refer to Window Adjustment - Endgate Cross Car.
8. Adjust the end gate window up/down. Refer to Window Adjustment - Endgate Up/Down.
9. Install the end gate inner panel reinforcement.
10. Install the end gate trim panel.
11. Install the regulator bolt access plugs (3).
12. Perform an end gate window learn cycle. Refer to Window Learn Cycle - Endgate.