69. Camshaft Installation - Right Intake

Camshaft Installation - Right Intake





1. Verify that the keyway on the crankshaft (2) is properly positioned.





2. Apply oil to the camshaft lobes and journals.
3. Install the right timing chain to the camshaft sprockets by aligning the silver or yellow links (1) with the marks (2, 3) on the camshaft sprockets.





4. Install the camshafts with the timing chain to the cylinder head.
5. Install the dowel pins (2) to the cylinder head.
6. Apply oil to the camshaft bearing cap bolts.





Important: Cylinder head and camshaft damage may result if the bearing caps are incorrectly installed.

7. Install the camshaft bearing caps. The caps are marked intake or exhaust (1), position away from the timing chain (2), and direction toward the timing chain (3).
8. Tighten the camshaft bearing caps.
- Tighten the camshaft bearing caps in 3 progressive steps in the sequence shown to 12 Nm (8.5 ft. lbs.).





9. Install the right secondary timing chain guide (1). Secure with the 2 bolts.
- Tighten the bolts to 11 Nm (7.5 ft. lbs.).
10. Install the right sprocket and primary timing chain.
11. Install the left secondary timing chain.
12. Install the engine front cover.