67. Camshaft Installation - Left Intake

Camshaft Installation - Left Intake





1. Verify that the keyway on the crankshaft (2) is properly positioned.
2. Apply engine oil to the camshaft journals and lobes.





3. Install the camshaft aligning the guide pin (1) with the mark (2) on the cylinder head.
4. Install the dowel pins to the cylinder head.





Important: Cylinder head and camshaft damage may result if the bearing caps are incorrectly installed.

5. Install the camshaft bearing caps. The caps are marked intake or exhaust (1), position away from the timing chain (2), and direction toward the timing chain (3).
6. Apply oil to the camshaft bearing cap bolts.





Notice: Refer to Fastener Notice in Service Precautions.

7. Tighten the camshaft bearing caps.
- Tighten the camshaft bearing caps in 3 progressive steps in the sequence shown to 12 Nm (8.5 ft. lbs.).