Front

INFLATABLE RESTRAINT FRONT END SENSOR REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

CAUTION: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 1.
2. Open the hood and support with prop rod.
3. Remove the engine splash shield.
4. Remove the radiator support and air cleaner assembly.
5. Carefully push the air conditioner condenser and radiator rearward and insert a wedge.




6. Remove the tow integral fasteners retaining the front discriminating sensors.
7. Remove the front sensor from the vehicle.




8. Disconnect the electrical connection position assurance (1).
9. Disconnect the electrical connection from the front sensor.

INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Connect the electrical connection to the front sensor.




3. Connect the electrical connection position assurance (1).

NOTE: Refer to Fastener Notice in Service Precautions.




4. Install the two bolts (1) retaining the front sensor.

Tighten
Tighten the bolts to 8.0 N.m (71 lb in).

5. Carefully remove the wedge that was holding the air conditioning condenser and the radiator.
6. Install the radiator support and air cleaner assembly.
7. Install the engine splash shield.
8. Close the hood.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1.