Rear

Transmission Housing Oil Seal Replacement - Rear (4WD)

Tools Required
^ J36825 Universal Seal Remover
^ J23907 Slide Hammer
^ J36502-2A Shaft Seal Protector/Installer
^ J36502 Extension Housing Seal Installer

Removal Procedure
1. Remove the transfer case.





2. Using the J36825 and the J23907 remove the seal from the extension housing.

Installation Procedure





1. Position J36502-2A over the output shaft.





2. Using J36502 Install the rear output shaft seal.





3. Remove J36502-2A from the output shaft.





4. Fill the space between the seal lips with grease GM P/N 1052497 or equivalent.
5. Install the transfer case.
6. Check the transmission oil level.
7. Lower the vehicle.