Latch/Support Cable Assembly Replacement - End Gate (Pickup)

Latch/Support Cable Assembly Replacement - End Gate (Pickup)

Removal Procedure





1. Safely support the endgate in the open position.
2. Remove the endgate bedliner.
3. Remove the endgate handle.
4. Disconnect the endgate support cable from the striker bolt through the keyhole slot.
5. Remove the bolts retaining the endgate latch/support cable assembly to the endgate.
6. Remove the latch assembly from the endgate.
7. Remove the latch rod from the slot in the latch assembly.


Installation Procedure





1. Install the latch rod to the slot in the latch/support cable assembly.
2. Install the latch assembly to the endgate.

Notice: Refer to Fastener Notice in Service Precautions.


3. Install the bolts retaining the endgate latch assembly to the endgate.

Tighten the latch assembly bolts to 28 N.m (21 lb ft).

4. Connect the endgate support cable to the striker bolt through the keyhole slot.
5. Install the endgate handle.
6. Install the endgate bedliner.