Isuzu T150 - Transfer Case

DTC C0550

Circuit Description
At each power-up, the transfer case shift control module runs a self-test on the following functions:
^ EEPROM Check-sum
^ ROM Checksum
^ RAM Checksum
^ RAM Malfunction

Conditions for Running the DTC
^ The ignition is ON.
^ System voltage is 9 - 16 volts.

Conditions for Setting the DTC
^ Critical operational parameters stored in EEPROM have failed Checksum test indicating invalid data.
^ Masked ROM code has failed Checksum test indicating that masked ROM data is not currently valid.
^ ROM code has failed Checksum test indicating that ROM data is not currently valid.
^ One or more RAM locations have failed operational test indicating that some portions of RAM are not functional.

Action Taken When the DTC Sets
^ The SERVICE 4WD indicator remains illuminated for the! remainder of the current ignition cycle.
^ Transfer case shifting is disabled.

Conditions for Clearing the DTC
Replace the transfer case shift control module. Perform the Diagnostic System Check Transfer Case.

Diagnostic Aids
Extremely low system voltage can cause this DTC to set falsely.

Test Description
The number below refers to the step number on the diagnostic table
2. This step replaces the transfer case shift control module.

Steps 1 - 2:

DTC C0550