Endgate Handle Replacement
HANDLE REPLACEMENT - END GATEREMOVAL PROCEDURE
1. Loosen the handle bolts.
2. Remove the handle bezel by prying gently on the upper retainer tabs.
3. Disengage the linkage rods (1).
4. Remove the handle bolts.
5. Remove the handle assembly from the endgate.
INSTALLATION PROCEDURE
1. Position the handle assembly on the endgate.
2. Install the handle bolts loosely.
3. Engage the linkage rods (1).
4. Install the handle bezel.
5. Tighten the handle bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).