Sunroof Switch Replacement With RPO Code Zrx/Extreme W/CF5

SUNROOF SWITCH REPLACEMENT (ZRX/EXTREME W/CF5)

REMOVAL PROCEDURE




1. With a medium flat-bladed tool, remove the motor/actuator service cover.
2. Remover the motor/actuator trim cover screw (2).




3. Lower the trim cover (5).
4. Remove the switch (4) from the cover.
5. Disconnect the motor/actuator electrical connector (3).




6. Remove the ground screw (3) and ground wire (2) from the header in behind the motor/actuator.
7. Disconnect the main feed electrical connector (1).
8. Remove the sunroof switch from the vehicle.

INSTALLATION PROCEDURE




1. Position the ground wire (2) to the header.
2. Install the ground screw (3).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the ground screw to 1.5 N.m (13 lb in).

3. Connect the main feed electrical connector (1).




4. Connect the electrical connector (3).
5. Operate the function of the sunroof switch (4).
6. Install the switch into the motor/actuator trim cover (5).




7. Position the cover to the sunroof panel window garnish molding (3).

IMPORTANT: Ensure the wires are positioned away from the trim cover attachment screw.

8. Install the motor/actuator trim cover screw (2).

Tighten
Tighten the screw to 1.5 N.m (13 lb in).

9. Install the motor/actuator service cover.