Compact Disc Player (CD): Service and Repair
REMOTE CD PLAYER REPLACEMENTREMOVAL PROCEDURE
IMPORTANT: Replace the CD and plastic bin as a whole assembly. Removing and installing the screws that attach the CD changer to the plastic bin may cause the CD changer to perform improperly.
1. Open the armrest (5) on the center console to reveal the remote CD changer assembly.
2. Remove the 2 front screws (1) and the rear screw (3) that attach the CD changer assembly to the center console.
3. Pull the CD changer assembly vertically out of the center console
4. Disconnect the electrical connector to the CD changer (4).
INSTALLATION PROCEDURE
1. Attach the electrical connector to the CD changer.
2. Install the CD changer assembly into the center console.
3. Install the front CD changer assembly retaining screws (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the front CD changer assembly retaining screws to 1.9 N.m (17 lb ft).
4. Install the rear CD changer assembly retaining screw.
Tighten
Tighten the rear CD changer assembly retaining screw to 2.5 N.m (22 lb ft).
5. Close the center armrest.