Rear Position Sensor Replace - Electronic Suspension - Right

REAR POSITION SENSOR REPLACEMENT - ELECTRONIC SUSPENSION - RIGHT

REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle.




3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect the sensor link from the ball stud.




5. Remove the bolts.
6. Remove the position sensor from the vehicle.

INSTALLATION PROCEDURE




1. Install the position sensor on the vehicle.
2. Install the bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the bolts to 12 N.m (106 lb in).

3. Connect the sensor link to the ball stud.




4. Connect the sensor harness connector to the vehicle harness connector.
5. Install the wheel to the vehicle.
6. Lower the vehicle.