Throttle Body: Service and Repair
THROTTLE BODY ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
1. Remove the resonator assembly from the throttle body.
2. Remove the evaporative emission (EVAP) canister purge line from the throttle body.
3. Disconnect the throttle body electrical connector.
4. Remove the throttle body assembly refraining fasteners.
5. Remove the throttle body assembly (2) and the gasket from the intake manifold.
6. Clean the gasket surface.
INSTALLATION PROCEDURE
1. Install the throttle body assembly to the intake manifold with the gasket.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the throttle body assembly retaining fasteners (1).
Tighten
Tighten the retaining fasteners to 10 N.m (89 lb in).