P0747

ALLISON AUTOMATIC TRANSMISSION

DTC P0747





Test 1-2





Test 3-11

Circuit Description for Allison Automatic Transmission

Important: DTC P0747 was previously P1723.

Trim Solenoid A is used to control on-coming, off-going, and holding pressure to any one of the five clutches. This solenoid is referred to as a Pressure Proportional to Current (PPC) solenoid since the output hydraulic pressure supplied by this solenoid is proportional to the controlled current command.
The Transmission Control Module (TCM) uses information from the turbine and output speed sensors to detect if a clutch is in a tie-up condition or 3 clutches are applied. The clutch being controlled by solenoid A will vary depending on the shift being made.
DTC P0747 is a type A DTC.

Conditions for Running the DTC
^ The components are powered and ignition voltage is greater than 9 V and less than 18 V.
^ One of the following conditions occurs:
- Output speed is greater than 200 RPM.
- Turbine speed is greater than 200 RPM.

Conditions for Setting the DTC
DTC P0747 sets when the TCM detects an incorrect ongoing ratio, range-to-range, for an accumulated number of occurrences.

Action Taken When the DTC Sets
^ When failure occurs in a forward range, the transmission will go to the previous range. If failure occurs in neutral or reverse, the transmission will lock in NEUTRAL while diagnostic response is active.
^ If the shift selector is moved to NEUTRAL, then the transmission will shift to NEUTRAL.
^ If the shift selector is moved to REVERSE, then the transmission will shift to REVERSE or NEUTRAL or in some cases may lock in NEUTRAL.
^ If the shift selector is returned to a forward range and the transmission is compromised by overspending or direction change, the transmission will shift to NEUTRAL.
^ DTC P0747 will be stored in the TCM history.
^ The TCM freezes shift adapts.
^ Illuminates the MIL when active.
^ TCM inhibits TCC engagement.

Conditions for Clearing the MIL/DTC
A scan tool can clear the code from the TCM history. The TCM automatically clears the DTC from the TCM history if the vehicle completes 40 warm-up cycles without failure.

Diagnostic Aids
^ This DTC indicates the off-going clutch being controlled by Solenoid A is is not releasing or is slow to release. This could indicate a leak or obstruction in a specific clutch apply circuit. Check scan tool failure record data for previous or current range information when the DTC was set to determine the specific shift when the DTC was set.

Important: Clutch failure due to installation of an engine power upgrade is not covered under the manufacturers warranty.

^ Inspect for the presence of an add-on engine power package. When engine horsepower or torque is increased over factory rating, a shift flare condition may occur.

Test Description
The numbers below refer to the step numbers on the diagnostic table.
3. This step tests for proper ignition voltage.
4. This step tests for erratic speed sensor readings or signal dropout.
5. This step tests for internal hydraulic leakage.
6. This step tests for clutch capacity.