Removal and Replacement

Rear Side Door Lock Actuator Replacement

Removal Procedure

1. Raise the window.
2. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Crew Cab) (Rear Side Door Trim Panel Replacement (Crew Cab)).
3. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement (Crew Cab) (Rear Side Door Water Deflector Replacement (Crew Cab)).




4. Disconnect the inside door lock rod from the handle retainer clip.




5. Disconnect the manual door lock rod from the door retainer clips.




6. Remove the rubber plug in order to disengage the outside handle rod retainer.




7. Disconnect the cylinder lock rod (1).
8. Remove the bolts (2) which retain the door lock actuator to the door.
9. Remove the door lock actuator and control rods as an assembly.
10. Disconnect the electrical connector from the door lock actuator, if equipped.
11. Remove the control rods as necessary.

Installation Procedure

1. Install the control rods to the assembly.
2. Connect the electrical connectors to the door lock actuator, if equipped.
3. Install the door lock actuator to the door.
4. Connect the outside door handle control rod.
5. Connect the cylinder lock rod.

Notice: Refer to Fastener Notice in Cautions and Notices.

6. Install the bolts which retain the door lock actuator to the door.

Tighten the screws to 9 Nm (80 lb in).




7. Connect the manual door lock to the door retainer clips.




8. Connect the inside door handle control rod to the lock assembly.




9. Connect the inside door lock rod to the handle retainer clip.
10. Install the water deflector. Refer to Rear Side Door Trim Panel Replacement (Crew Cab) (Rear Side Door Trim Panel Replacement (Crew Cab)) or Rear Side Door Water Deflector Replacement (Crew Cab) (Rear Side Door Water Deflector Replacement (Crew Cab)).
11. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Crew Cab) (Rear Side Door Trim Panel Replacement (Crew Cab)).
12. Inspect the operation of all the related components.