P0182

DTC P0182

Circuit Description

The fuel tank temperature (FTT) sensor is a variable resistor that measures the temperature of the fuel in the CNG fuel tank. The alternative fuels ECM supplies 5 volts to the FTT signal circuit and supplies a ground to the low reference circuit. If the alternative fuels ECM detects a low FTT signal voltage, which is a high temperature indication, this DTC sets.


Conditions for Running the DTC

The ignition is ON.


Conditions for Setting the DTC

The alternative fuels ECM detects that the fuel tank temperature sensor voltage is less than 0.05 V for more than 5 seconds.


Action Taken When the DTC Sets

The alternative fuels ECM records the operating conditions at the time the diagnostic fails. The Alternative Fuels ECM stores this information in the Freeze Frame and/or Failure Records.


Conditions for Clearing the MIL/DTC

* A last test failed, or current DTC, clears when the diagnostic runs and does not fail.
* A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
* Use a scan tool in order to clear the MIL and the DTC.



Diagnostic Aids

* Use the Temperature vs Resistance table in order to test the FTT sensor at various temperature levels in order to evaluate the possibility of a skewed sensor. A skewed sensor could result in a driveability condition. If the engine has sat overnight, the FTT sensor and the intake air temperature values should display within a few degrees. If the temperatures are not within 3°C (5°F), refer toFuel Tank Temperature (FTT) Sensor Output Voltage vs Temperature Resistance Electrical Specifications
* For an intermittent condition, refer to Intermittent Conditions Initial Inspection and Diagnostic Overview