Generator Replacement

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the drive belt.
3. Disconnect the generator electrical connector (1).




4. Remove the generator bolts.
5. Remove the generator.




6. Remove the generator cable from the generator, perform the following:
6.1. Slide the boot down revealing the terminal stud.
6.2. Remove the generator cable nut from the terminal stud.
6.3. Remove the generator cable.

INSTALLATION PROCEDURE




1. Install the generator cable to the generator, perform the following:
1.1. Install the generator cable.

NOTE: Refer to Fastener Notice in Service Precautions.

1.2. Install the generator cable nut to the terminal stud.

Tighten
Tighten the generator cable nut to 9 N.m (80 lb in).

1.3. Slide the boot over the terminal stud.




2. Install the generator.
3. Install the generator bolts.

Tighten
Tighten the generator bolts to 50 N.m (37 lb ft).




4. Connect the generator electrical connector (1).
5. Install the drive belt.
6. Connect the negative battery cable.