Electronic Column Lock Module - Assemble

Electronic Column Lock Module -Assemble - Off Vehicle (Tilt Column)





1. Install the lock bolt spring (3) into the steering column tilt head assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column tilt head assembly (5).
4. Push the lock bolt assembly (4) into the steering column tilt head assembly (5) until the lock bolt assembly is flush with the steering column tilt head assembly (5).
5. Align the electronic lock module assembly (2) with the steering column tilt head assembly (5).

Notice: Refer to Fastener Notice in Service Precautions.

6. Screw the 3 pan head tapping screws (1) into the electronic lock module assembly (2).
- Tighten the screws to 7 Nm (62 inch lbs.).





Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.

7. Place steering column lock cylinder set into the OFF position.
8. Place the shift lever clevis into the PARK position.
9. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.
10. Install the ignition and key alarm switch assembly only.
11. Install the upper tilt head components.
12. Install the ignition lock cylinder.
13. Enable the inflatable restraint steering wheel module.