P0650

CIRCUIT DESCRIPTION
Ignition voltage is supplied directly to the Malfunction Indicator Lamp (MIL). The Engine Control Module (ECM) controls the lamp by grounding the control circuit through an internal switch called a driver. The primary function of the driver is to supply the ground for the component being controlled. Each driver has a fault line which is monitored by the ECM. When the ECM is commanding a component ON, the voltage of the control circuit should be low, near 0 volts. When the ECM is commanding the control circuit to a component OFF, the voltage potential of the circuit should be high, near battery voltage. If the fault detection circuit senses a voltage other than what is expected, the fault line status will change causing the Diagnostic Trouble Code (DTC) to set.

CONDITIONS FOR RUNNING THE DTC
^ The engine speed is more than 400 RPM.
^ The ignition voltage is between 6-18 volts.

CONDITIONS FOR SETTING THE DTC
^ The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match.
^ The conditions are present for a minimum of 5 seconds.

ACTION TAKEN WHEN THE DTC SETS
^ The control module illuminates the Malfunction Indicator Lamp (MIL) when the diagnostic runs and fails.
^ The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame/Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC
^ The control module turns OFF the Malfunction Indicator Lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
^ A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
^ Use a scan tool in order to clear the MIL and the DTC.

TEST DESCRIPTION

Steps 1-8:

Steps 9-19:

The numbers below refer to the step numbers on the diagnostic table.
5. This step tests for a short to ground in the MIL control circuit. With the ECM disconnected and the ignition ON the MIL should be OFF.
6. This step tests for a short to voltage on the MIL control circuit. With the fuse removed there should be no voltage on the MIL control circuit.
17. This vehicle is equipped with a ECM that utilizes an electrically Erasable Programmable Read Only Memory (EEPROM). When the ECM is being replaced, the new ECM must be programed.