P0182

CIRCUIT DESCRIPTION
The fuel temperature sensor is a thermistor that controls signal voltage to the Powertrain Control Module (PCM). When the fuel is cold, the sensor resistance is high, therefore the PCM will see high signal voltage. As fuel warms, sensor resistance becomes less and voltage drops. The fuel temperature sensor is integrated with the optical sensor.

CONDITIONS FOR RUNNING THE DTC
^ The PCM performs this Diagnostic Trouble Code (DTC) diagnostic continuously.
^ The ignition in the ON position.

CONDITIONS FOR SETTING THE DTC
^ The fuel temperature is more than or equal to 102°C (215°F).
^ All of the diagnostic set conditions are met for 2 seconds.

ACTION TAKEN WHEN THE DTC SETS
^ The control module illuminates the Malfunction Indicator Lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
^ The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC
^ The control module turns OFF the Malfunction Indicator Lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
^ A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
^ Use a scan tool in order to clear the MIL and the DTC.

DIAGNOSTIC AIDS
A scan tool reads fuel temperature in degrees centigrade.

An intermittent may be caused by any of the following conditions:
^ A poor connection
^ Rubbed through wire insulation
^ A broken wire inside the insulation

Thoroughly check any circuitry that is suspected of causing the intermittent complaint. Refer to Testing for Electrical Intermittents in Diagrams.

If a repair is necessary, then refer to Wiring Repairs or Connector Repairs in Diagrams.

TEST DESCRIPTION

Steps 1-10:

The numbers below refer to the step numbers on the diagnostic table.
2. This step determines if DTC P0182 is a hard failure or an intermittent condition.
3. This test will determine if the signal circuit is shorted to ground.