Turn Signal & Multifunction Switch - Assemble

Assembly Procedure

Important: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.





1. Install the turn signal and multifunction switch assembly.

Notice: Refer to Fastener Notice in Service Precautions.





2. Install the 2 pan head tapping screws.
- Tighten the screws to 7 Nm (62 inch lbs.).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly onto the bulk head connector (1).





4. Install the wire harness assembly (4) into the wire harness strap (5).
5. Install the wire harness strap (2) into the steering column tilt head assembly (1).
6. Install the wire harness straps (3) onto the wire harness assembly (4).
7. Install the upper and lower shrouds. Refer to
Steering Column Trim Covers - Assemble -Off Vehicle.