Electronic Column Lock Module - Assemble

Assembly Procedure
1. Install the lock module assembly (1).

Notice: Refer to Fastener Notice in Service Precautions.





2. Install the 3 pan head tapping screws (2) into the lock module assembly.
Tighten the screws to 1.5 Nm (13 inch lbs.).





3. Install the park lock cable assembly (1) into the lock module assembly.





4. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.
- Tighten the screws to 4.7 Nm (42 inch lbs.).





5. Slide the PASSKEY 111 (2) onto the lock module assembly (1).
6. Install the steering column tilt head assembly. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle.