Adjusting the Speakers

BAL
Press and release the P-TYPE LIST/AUDIO knob until BAL appears on the display. Turn the knob clockwise to move the sound to the right speakers an counterclockwise to move the sound to the left speakers. The middle position balances the sound between the speakers. The display will show the speaker balance. To set the control to the middle position, select the control and press and hold the P-TYPE LIST/AUDIO button. The radio will produce one beep and set the display level to the middle position.

FADE
Press and release the P-TYPE LIST/AUDIO knob until FADE appears on the display. Turn the knob clockwise to the front speakers and counterclockwise to move the sound to the rear speakers. The middle position balances the sound between the speakers. The display will show the speaker balance.

USING RDS MODE (UT6, U1P, U1Q)
The audio system is equipped with a Radio Data System (RDS). RDS mode gives you many useful new features. With RDS, the radio can:
^ Seek only to stations with the types of programs you want to listen to.
^ Seek to station with traffic announcements
^ Receive announcements concerning local and national emergencies.
^ Receive and display messages from radio stations.

RDS features are only available for use on FM stations which broadcast RDS information. The RDS features of you radio rely upon receiving specific RDS information from these stations. These features will only work when the RDS information is available. In rare cases, a radio station may broadcast incorrect information that will cause the radio features to work improperly. If this happens, please contact the radio station. When you are tuned to an RDS station, the station name will appear on the display, instead of the frequency. Most RDS stations provide there station name, the time of day and Program Type (PTY) for their current programming.

For a description of the RPO Code(s) shown in this article, refer to the RPO Code List found at Vehicle/Application and ID. Application and ID