Compressor Clutch Coil Install (HT6 - Direct Mount)

TOOLS REQUIRED
^ J 8433 Compressor Pulley Puller
^ J 8433-3 Forcing Screw
^ J 33024 Clutch Coil Installer Adaptor
^ J 33025 Clutch Coil Puller Legs
^ J 41790 Compressor Holding Fixture




1. Place the clutch coil assembly (1) on the front head with the clutch coil terminal positioned at the mark made during disassembly.
2. Place the J 33024 over the internal opening of the clutch coil housing and align installer with the compressor front head.
3. Install the J 8433-3 into the J 8433 and center the screw in the countersunk center hole of the J 33024.
4. Install the 4 inch through bolts and washers from the J 42136 tool kit into the J 33025 and attach them to the compressor mounting bosses.
5. Turn the center forcing screw of the J 8433 to press the clutch coil onto the front head until the clutch coil is fully seated.
Ensure that the clutch coil and the J 33024 remain aligned with each other while pressing the clutch coil onto the compressor.
6. Install the compressor clutch rotor and bearing assembly.
7. Remove the compressor from the J 41790.
8. Install the compressor into the vehicle.