Generator Brace Replacement - Auxiliary (CS 130D)

REMOVAL PROCEDURE
1. Remove the drive belt.






2. Remove the mounting bolts from the brace. The right-mounted version of the same generator is supported by a different brace at the rear of the generator.
3. Remove the brace.

INSTALLATION PROCEDURE






1. Install the brace.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the mounting bolts to the brace.

Tighten
- Tighten the auxiliary generator mounting long bolts to 50 N.m (37 lb ft).
Tightening specifications include bolts for right mounted brace.
- Tighten the auxiliary generator mounting short bolts to 25 N.m (18 lb ft).
3. Install the drive belt.