Removal and Replacement

Door Lock Actuator Replacement

Removal Procedure

Tools Required

J 34940 Rivet Gun





1. Remove the trim panel, as necessary.
2. Remove the water deflector, as necessary.
3. Remove the access hole cover, as necessary.




4. Remove the actuator lock control rod (1).
5. Disconnect the actuator wiring connector.
6. Drill out the rivets using an 3 mm (.125 in ) drill bit.
7. Remove the actuator from the door.



Installation Procedure





1. Using the J 34940 with rivets, install the actuator to the door.
2. Install the actuator lock control rod (1).
3. Connect the actuator wiring connector.




4. Install the water deflector, as necessary.
5. Install the trim panel, as necessary.
6. Install the access hole cover, as necessary.