B2960

Diagnostic Chart (Part 1 Of 2):

Diagnostic Chart (Part 2 Of 2):

Schematic:

CIRCUIT DESCRIPTION
The EVO/Passlock (TM) module will read an analog voltage from the Passlock (TM) sensor. Based on an internal reference, the EVO/passlock (TM) module will determine it the measured voltage is open, shorted to ground, a valid code, or a tamper code. There are 10 possible valid code combinations. The EVO/Passlock (TM) module will only accept the last learned valid code.

CONDITIONS FOR SETTING THE DTC
- The EVO/Passlock (TM) module will inspect for a valid code when the ignition is rotated from ON to crank and will continue to monitor the signal during the engine running period.
- The EVO/Passlock (TM) module is reading a different code value than previously learned from the Passlock (TM) sensor.

ACTION TAKEN WHEN THE DTC SETS
- The vehicle will not run if the fault occurs before the vehicle is started. The security telltale will be flashing.
- If the vehicle is running when the fault occurs, the EVO/Passlock (TM) module will be in the fail enabled mode allowing the vehicle to start and run. The security telltale will be ON.

CONDITIONS FOR CLEARING THE DTC
- The DTC will clear after an ignition cycle has occurred without the fault.
- EVO/Passlock (TM) module history codes will be cleared after 100 ignition cycles with no current codes active.
- Using a scan tool

DIAGNOSTIC AIDS
- When replacing the Passlock (TM) sensor, all the sensor components; the lock, the sensor, the filter, and the harness, are included as a replacement part and must be replaced.
- Use the scan tool in order to test the Passlock (TM) data voltage and the Passlock (TM) code.
- Perform a visual inspection of the wiring and the connectors.
- Inspect the Passlock (TM) sensor harness and the filter for an intermittent or poor connections (including the in-line connector). Refer to Testing for Intermittent and Poor Connections in Diagrams.

TEST DESCRIPTION
The numbers below refer to the numbers on the diagnostic table.
2. If the Passlock (TM) sensor has been replaced without the Passlock (TM) Learning Procedure, DTC B2960 will set.
3. This step will determine if the problem is in the Passlock (TM) sensor or the EVO/Passlock (TM) module. A 5 volt signal is normal for the Passlock (TM) signal input with the Passlock (TM) sensor disconnected.