Plastic Collar

TOOL REQUIRED
J 34730-1A Fuel Pressure Gauge

REMOVAL PROCEDURE




1. Relieve the fuel system pressure before servicing any fuel system connection. Refer to the Fuel Pressure Relief Procedure.

CAUTION: Refer to Safety Glasses and Compressed Air Caution in Cautions and Notices.

2. Using compressed air, blow any dirt out of the quick-connect fitting.

IMPORTANT: Plastic quick connect fittings can be released either by squeezing the plastic retainer release tabs or by using the appropriate J 37088-A fuel line quick-connect separator tool.




3. Squeeze the plastic retainer release tabs.




4. Choose the correct tool from the J 37088-A tool set for the size of the fitting. Insert the tool into the female connector, then push inward in order to release the locking tabs. The plastic retainer remains on the female connector.




5. Pull the connection apart.

INSTALLATION PROCEDURE

CAUTION: Refer to Fuel Pipe Fitting Caution in Cautions and Notices.




1. Apply a few drops of clean engine oil to the male fuel pipe end.




2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.




3. Once installed, pull on both sides of the quick-connect fitting in order to make sure the connection is secure.