Differential Assembly Installation

^ Tools Required
- J 36612 Bearing Installer (4WD 15 Series and 4WD 25 Series)
- J 36513 Driver Handle
- J 36599 Sleeve Adjusting Wrench
- J 36603 Side Bearing Cup Installer





1. For the 4WD 15 Series and 4WD 25 Series models, use the J 36513 and the J 36612 in order to install the bearings to the sleeves.





2. For the 4WD 15 Series and 4WD 25 Series models, use J 36599 in order to install the sleeves to the carrier case.
3. Use the J 36603 with the J 8092 in order to install the side bearing cups.





4. Install the differential assembly to the carrier case half.
^ Place the differential assembly into the carrier case half which contains the pinion gear.
^ For 4WD 15 Series and 4WD 25 Series models, use the J 36615 in order to turn the left sleeve in until the backlash is felt between the ring and the pinion.





5. Remove the carrier case from the J 36599
6. Install the carrier case halves.
Do not use sealer at this time.
If the carrier halves do not make complete contact, use the J 36599 in order to back out the right sleeve.

Notice: Refer to Fastener Notice in Service Precautions.

7. Install the bolts.
Tighten the bolts to 47 Nm (35 ft. lbs.).